AccuStrata FLUOROTEK 200 사용 설명서 - 페이지 4

{카테고리_이름} AccuStrata FLUOROTEK 200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuStrata FLUOROTEK 200 17 페이지. Handheld fluorometer
AccuStrata FLUOROTEK 200에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

2. Install 4 - AA batteries as indicated at the bottom of the battery housing.

3. Replace the battery protection panel by inserting the panel into the groves and sliding up

into position.

1.4. General Information, Precautions and Cleaning



The sample compartment is designed to accommodate standard polypropylene 0.5 ml

Polymerase Chain Reaction tubes as shown below:



Any other sample holder besides those displayed above are not guaranteed to fit

properly in the sample holder. Do not use solvents inthe test tube that may penetrate or

degrade the integrity of the tube. See tube manufacture instructions for further

information.



If a sample is accidentally spilled inside the sample compartment, invert the Fluorotek

200 unit to drain the fluid from the compartment. Then carefully wipe the inside of the

compartment with a clean cotton swab or cloth. Allow the unit to dry before using.



The Fluorotek 200 is NOT waterproof and should be kept away from water and moisture.



Do not expose the Fluorotek 200 unit to temperatures below 5 ⁰C or above 40 ⁰C.

2. Instrument Operation

2.1.

Instrument Power Up

To turn on the Fluorotek 200, toggle the power switch on the top right side of the unit to the left.

To turn the unit off, toggle the power switch right.

If the Fluorotek 200 is left on for more than 30 minutes, the unit will power off automatically.

Once the system is turned on, a

Once the

OME

CREEN

AccuStrata Fluorotek 200 User's Manual

OADING

CREEN

appears, the system is ready for use.

will appear followed by the

OME

CREEN

3 |

P a g e