AccuStream DiaLine Cutting head 매뉴얼 - 페이지 17
{카테고리_이름} AccuStream DiaLine Cutting head에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuStream DiaLine Cutting head 20 페이지.
페이지 인쇄AccuStream Cutting Systems
4.8 Troubleshooting
Cutting Head
Problem
Orifices do not last at least 20 hours
Nozzle Life too short or not wearing
round
Abrasive not drawing into head
properly
Can't unplug nozzle
Leak Points (Causes and Solutions)
13084 ON/OFF VALVE & CUTTING HEAD MANUAL
Solution
Not flushing thoroughly when changing orifice
Bad water quality
Blown in-line filter upstream
In the A2 head rotate nozzle 120° every shift or 8 hours
Using too much abrasive.
Running with worn orifice.
Vacuum leak, check inlet tube connection
Smaller combinations such as .007/.020 may need to have
the nozzle lowered about ¼" to induce more vacuum
Put nozzle upside down in head and cycle jet on/off
Item
Problem
Seal Weep hole.
1
2
Inlet Weep hole.
3
Leakage at bottom
of valve body.
Head Weep hole.
4
5
Dripping Nozzle
when valve closes.
15
Solution
Replace Valve
Seal kit.
Tighten inlet
fitting.
Tighten adapter to
valve body or
tighten inlet fitting
in collar.
Tighten Head to
Adapter.
Needle and Seat
are worn and need
new valve kit.