DIGISYSTEM APN20201 사용 설명서 - 페이지 7
{카테고리_이름} DIGISYSTEM APN20201에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGISYSTEM APN20201 9 페이지. Variable frequency vibrators power supply
페이지 인쇄
PROBLEMS SOLUTION
fault
Led DL2 switches regularly on and off
Switching on I1 the lamp L1 doesn't
switch on and DL2 lights momentary on
Switching on I1 the lamp L1 doesn't
switch on and DL2 doesn't light at all
Switching on I1 the lamp L1 switches
on, led DL1 is off and led DL2 switches
momentary on, but vibration doesn't
start
Switching on I1 the lamp L1 switches
on, led DL1 is on and led DL2 switches
momentary on, but vibration doesn't
start
If actions remarked on the table doesn't resolve the problem you may contact factory
digisystem srl (e-mail
OPENING INSTRUCTIONS
As on the electronic card there are some capacitors with high voltage applied (presence of
residuary energy, danger of strike) you must wait at least 4 - 5 minutes after the device is
disconnected from the power supply, before opening the box.
Switch I1 off and disconnect mains cable
Remove the knob (take the lid off and unlose the screw or nut), unlose the nut of the
potentiometer and the four screws X3 on the panel.
Lamp L1 failure
functional
anomaly
Overload
Rotate P3 counterclockwise to
condition
Device not
Verify mains supply and input
supplied
fuses; to locate fuses F1 see
instructions to open the device
There is not
Place switch SW2 to on or send
start command
a external start command from
Vibrator not
supplied
supply to vibrator; if the wiring
is correct there is probably a
failure on drivers into the power
) we will help you.
7
What to do
decrease the output power
Substitute switch
input cable
Check wiring from power
supply