Sharp CD-DH790NH 운영 매뉴얼 - 페이지 14

{카테고리_이름} Sharp CD-DH790NH에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp CD-DH790NH 34 페이지. Mini component system

페이지 인쇄

System connections

Make sure to unplug the AC power lead before making any connections.

AM loop aerial

Installing the AM loop

aerial

< Assembling >

< Attaching to the wall >

wall

screws

(not supplied)

FM aerial

Right speaker

Wall socket (AC 220 - 240 V ~ 50/60 Hz)

■ Aerial connection

Supplied FM aerial:

Connect the FM aerial wire to the FM 75 OHMS socket and

position the FM aerial wire in the direction where the

strongest signal can be received.

External FM aerial:

Use an external FM aerial (75 ohms coaxial cable) for

better reception. When an external FM aerial is used,

disconnect the supplied FM aerial wire.

Supplied AM loop aerial:

Connect the AM loop aerial to the AM and GND terminals.

Position the AM loop aerial for optimum reception. Place

the AM loop aerial on a shelf, etc., or attach it to a stand or

a wall with screws (not supplied).

Note:

Placing the aerial on the unit or near the AC power lead

may cause noise pickup. Place the aerial away from the

unit for better reception.

■ Speaker connection

● Connect the black wire to the

minus (–) terminal, and the red

wire to the plus (+) terminal.

● Use speakers with an

impedance of 4 ohms or more,

as lower impedance speakers

can damage the unit.

● Do not mistake the right and

the left channels. The right

speaker is the one on the right

side when you face the unit.

● Do not let the bare speaker

wires touch each other.

● Do not allow any objects to fall into or to be placed in

the bass reflex ducts.

● Do not stand or sit on the speakers. You may be

injured.

■ Demonstration mode

● The first time the unit is plugged in, the unit will enter

● To cancel the demonstration mode, press the DEMO

● To return to the demonstration mode, press the DEMO

■ Connecting iPod to a TV

The iPod with photo and video can be viewed by

connecting to a TV/monitor.

If the TV/monitor has a video input, connect it to the VIDEO

OUT socket on the rear of the unit.

Note:

Please make sure to set iPod unit to either NTSC or PAL

to match your TV signal. Please visit Apple's homepage for

further information.

■ AC power connection

After checking all the connections have been made

correctly, plug the AC power lead of this unit into the wall

socket If you plug in the unit ﬁrst, the unit will enter the

stand-by mode.

Note:

Unplug the AC power lead from the wall socket if the unit

Incorrect

will not be in use for a prolonged period of time.

E-5

input socket

the demonstration mode. You will see words scroll.

button (remote control) during power stand-by mode.

The unit will enter the low power consumption mode.

button again.

To video

Video cable

(not supplied)

Left

speaker

Red

Black