Sharp CD-DH790NH 운영 매뉴얼 - 페이지 24
{카테고리_이름} Sharp CD-DH790NH에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp CD-DH790NH 34 페이지. Mini component system
페이지 인쇄Listening to a cassette tape
Note:
Tape recording function is not available in this unit.
Before playback:
● For playback, use normal or low-noise
tapes for the best sound. (Metal or
CrO
tapes are not recommended.)
2
● Do not use C-120 tapes or poor-quality
tapes, as they may cause malfunctions.
● Before loading a tape into the cassette
compartment, tighten the slack with a pen
or a pencil.
ON/STAND-BY
ON/STAND-BY
AUDIO IN
AUDIO IN
PHONES
PHONES
CD
USB
M I N I C OM PON EN T SY STE M
CD-DH790
FUNCTION
FUNCTION
ON/STAND-BY
ON/STAND-BY
VOL
VOL
PUSH
PUSH
OPEN
OPEN
TAPE
■ Tape playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button on main unit repeatedly
or TAPE button on remote control to select TAPE
function.
3
Open the cassette door
by pushing the area
marked "
PUSH OPEN".
4
Load a cassette into the
cassette compartment.
5
Press the
/ (TAPE
Auto power on function:
When you press any of the following buttons, the unit turns
on.
● TAPE button (remote control): The unit turns on and
the "TAPE" function is activated.
●
/
button on the main unit: The unit turns on and
playback of the last function starts (iPod, CD, TUNER,
USB, AUDIO IN, TAPE).
Auto power off function:
In the stop mode of tape operation, the main unit enters the
stand-by mode after 15 minutes of inactivity.
■ Various tape functions
Function
Main
unit
Tape
playback
Stop
____
Fast
forward/
Fast rewind
Caution:
● To remove the cassette, press the
and then open the compartment.
● If a power failure occurs during tape operation, the tape
head will remain engaged with the tape and the
cassette door will not open. In this case, wait until the
power is restored.
E-15
) button to start playback.
Remote
Operation
control
Press in the stop
mode.
Press in the
playback, fast
forward or fast
rewind mode.
Press in the
playback or stop
mode.
(TAPE
) button,