Sharp Notevision PG-M10S 운영 매뉴얼 - 페이지 21

{카테고리_이름} Sharp Notevision PG-M10S에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Notevision PG-M10S 49 페이지. Digital multimedia projector
Sharp Notevision PG-M10S에 대해서도 마찬가지입니다: 운영 매뉴얼 (49 페이지), 기본 정보 및 준비 사항 (10 페이지)

페이지 인쇄

Adjuster Adjustment

There are two adjusters: one on the right side of the back

panel and another in the front center of the unit.

1 Use right hand to lift the front of the unit to

approximately the desired adjustment angle.

2 Press the foot release button on the front.

Loosen the foot release and allow it to drop into position.

3 Release the button.

The extended foot release will be locked.

4 Rotate the contact surfaces of the rear adjuster either

clockwise or counterclockwise to accurately adjust the

level.

Down

When distortion of the projected image

cannot be corrected with the adjusters,

press the KEYSTONE +/– buttons of the

remote control to fine adjust (see page 22).

Using KEYSTONE to adjust projected image

distortion.

ENLARGE

KEYSTONE

VOLUME

Maximum correction is 14 degrees (including optical

correction).

The top and bottom of the projected image is

corrected, as shown below.

If a menu is being displayed, distortion of the menu

will not be corrected.

Down

Adjust the image size to match the distance

to the screen. Next, use the focus ring to

adjust the focus.

Change the unit setting to suit the method

and source selected in step 4.

• Select the "PROJECTION" appropriate for

the type of projector installation. (See

page 33)

If the image is projected reversed, vertically, or

horizontally, reset "PROJECTION".

• In the case of video or S-video, select the

color system as necessary. (See page 30)

Normally, it is not necessary to change the factory

settings. Also, set the COMPUTER input terminal

for YP

(component video). (See page 31)

• In the case of RGB input, adjust the video

of the connected PC.

This unit automatically identifies the input signal

and selects the most appropriate resolution.

However, manually adjust the "CLOCK" and

"PHASE" (see page 28) when there is flicker,

noise, color offset, etc., and manually adjust the

vertical and horizontal position (see page 28)

when the image is not centered.

You can maintain the original aspect ratio of the

incoming signal. (see page 31). (Normally, the

resolution is automatically detected and the

display is enlarged or reduced.)

Adjust the picture elements (see page 26),

then select the picture type according to the

video content (see page 30).

Start using the unit.

The following functions are available while using the

unit:

• Adjusting the volume of the unit's speaker

(see pages 22 and 32),

• Turning off the image and muting the sound

temporarily (see page 22),

• Freezing a moving picture (see page 22),

• Enlarging the picture (see page 23)

When there is no signal input for a period of 5 min. or more,

the power is automatically turned off and standby status is

activated.

Using the unit

Focus ring