Sharp Notevision PG-M10S 운영 매뉴얼 - 페이지 8

{카테고리_이름} Sharp Notevision PG-M10S에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Notevision PG-M10S 49 페이지. Digital multimedia projector
Sharp Notevision PG-M10S에 대해서도 마찬가지입니다: 운영 매뉴얼 (49 페이지), 기본 정보 및 준비 사항 (10 페이지)

페이지 인쇄

Usage Guidelines

95˚F

(+35˚C)

41˚F

(+5˚C)

For SHARP Assistance (U.S.A. only)

If you encounter any problems during setup or operation of this projector, first refer to the "Troubleshooting" section on page

35. If this operation manual does not answer your question, please call toll free 1-888-GO-SHARP (1-888-467-4277) for further

assistance. Or, send us an e-mail at [email protected].

Our World Wide Web address is http://www.sharp-usa.com/.

Caution Concerning the Lamp Unit

Potential hazard of glass particles if lamp has ruptured. Please have

Sharp Authorized LCD Projector Dealer or Service Center replace

lamp if rupture occurs.

See "Replacing the Projection Lamp" on page 37.

BQC-PGM10X//1

Cautions Concerning the Setup of the Projector

For minimal servicing and to maintain high image quality, SHARP

recommends that this projector be installed in an area free from

humidity, dust and cigarette smoke. If the projector is used in these

environments, the lens will need to be cleaned more often, and

internal cleaning may become necessary. As long as the projector is

10 X

PG -M

regularly cleaned, use in these environments will not reduce the

overall operation life of the unit. Internal cleaning should only be

performed by a Sharp Authorized LCD Projector Dealer or Service

Center.

Notes on Operation

• The three marks shown on the left are caution labels for parts of

• The cooling fan (exhaust vent), the lamp cage cover and adjacent

• Allow at least 10 cm (3

10 X

PG -M

• If the cooling fan becomes obstructed, a protection device will

10 X

PG -M

the projector that emit intense heat during operation.

areas may be extremely hot during projector operation. To prevent

injury, do not touch these areas until they have sufficiently cooled.

inches) of space between the cooling

fan (exhaust vents) and the nearest wall or obstruction.

automatically turn off the projector lamp. This does not indicate a

malfunction. Remove the projector power cord from the wall outlet

and wait until the projector has sufficiently cooled. Then turn on the

power by plugging the power cord back in. This will return the

projector to the normal operating condition.