DIGITAL AGILE SKYMOD1 설치 지침
{카테고리_이름} DIGITAL AGILE SKYMOD1에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGITAL AGILE SKYMOD1 2 페이지. Audio/video modulator
페이지 인쇄DIGITAL AGILE AUDIO/VIDEO MODULATOR
I. Modulator Installation:
1.
Insert the male RCA connector from the video source into the SKYMOD1 RCA jack.
2.
Insert the 3.5mm miniature plug from the audio source into the SKYMOD1 audio input
(Mini jack)
3.
Connect F to F connecting cable from RF output (F-Female connector on SKYMOD1) to
one output port of a splitter.
4.
Connect cable from Off-Air or CATV line or any other RF signal source to other port of
splitter.
5.
Connect input of splitter to TV RF Input.
6.
Plug the provided 12 VDC, 100 mA power supply into the power line and SKYMOD1
power jack.
This completes the installation of SKYMOD1 modulator
II.
Channel Programming Steps:
Step1 – Using Paper clip or ball point pen, press and hold "select"
Step2 – Release button and press "channel" button up or down while LED is flashing. When LED stops
flashing, channel selection is complete.
SKYMOD1
INSTALLATION INSTRUCTIONS