Shimano BR-IM86 딜러 매뉴얼 - 페이지 16

{카테고리_이름} Shimano BR-IM86에 대한 딜러 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano BR-IM86 27 페이지. Hub roller brake

Shimano BR-IM86 딜러 매뉴얼
INSTALLATION

Installation of the brake cable

„ Installation of the brake cable
Rear side
(A)
1
(B)
2
3
To be continued on next page
After checking that the cable
(C)
adjustment barrel (B) and adjustment
nut (A) are fully tightened, insert the
outer holder unit (C) into the inner
cable in the direction shown in the
illustration.
After checking that the marking of the
back side of the inner cable fixing bolt
(a)
unit (D) is "R", pass the inner cable
through the hole of the inner cable
fixing bolt unit.
(D)
Place the components as shown in the
following figure and tighten the inner
cable fixing nut (E).
(b)
Use (b) 99 mm of TL-IM21 (F) to
(E)
tighten the inner mounting nut as
shown in the illustration.
(F)
(a)
"R" marking
16
(A)
Adjustment nut
(B)
Cable adjustment barrel
(C)
Outer holder unit
(D)
Inner cable fixing bolt unit
(E)
Inner cable fixing nut
(F)
TL-IM21
Tightening torque
6 - 8 N·m
NOTE
After tightening, check that the
orientations of the inner cable fixing nut
and inner cable are correct as shown in
the illustration.
Never tighten the inner cable fixing bolt
with it attached to brake. The
orientations of the inner cable fixing nut
and inner cable will become improper as
shown in the illustration, which may
cause the inner cable fixing bolt to
detach from the brake body.