Shimano CLARIS FC-R2030 딜러 매뉴얼 - 페이지 14
{카테고리_이름} Shimano CLARIS FC-R2030에 대한 딜러 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano CLARIS FC-R2030 20 페이지. Crankset
페이지 인쇄INSTALLATION
Installing the crank arms
(B)
3
(A)
(z)
4
(B)
(C)
(C)
(A)
Use the SHIMANO original tool to
tighten the cap.
Push in the stopper plate and check that
the plate pin is securely in place, and
then tighten the screws of the left crank
arm.
Tighten both screws equally to the
specified tightening torque (12 - 14 N·m).
(z)
The illustration is of the left crank
arm (cross-section)
14
(A)
TL-FC16
(B)
Cap
(C)
Apply grease:
Premium Grease
(Y04110000)
Tightening torque
0.7 - 1.5 N·m
(A)
Plate pin
(B)
Stopper plate
(C)
Left crank arm
Tightening torque
12 - 14 N·m
NOTICE
•
The two screws should be tightened
alternately in stages rather than each screw
being fully tightened at once.
•
Set the stopper plate in the correct
direction as shown in illustration.