Shimano FC-MT500-B2 매뉴얼 - 페이지 17
{카테고리_이름} Shimano FC-MT500-B2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano FC-MT500-B2 26 페이지.
페이지 인쇄INSTALLATION
Installing the crank arms
(z)
(A)
4
(B)
(C)
Push in the stopper plate and check that
the plate pin is securely in place, and
then tighten the screws of the left crank
arm.
Tighten both screws equally to the
specified tightening torque (12 - 14 N·m).
(z)
The illustration is of the left crank
arm (cross-section)
17
(A)
Plate pin
(B)
Stopper plate
(C)
Left crank arm
Tightening torque
12 - 14 N·m
NOTICE
•
The two screws should be tightened
alternately in stages rather than each screw
being fully tightened at once.
•
Spacers used vary according to the width of
the bottom bracket shell. For details, refer
to "Spacer installation method".
•
Set the stopper plate in the correct
direction as shown in illustration.