Shimano Ultegra SM-BCR2 도움말 매뉴얼 - 페이지 26
{카테고리_이름} Shimano Ultegra SM-BCR2에 대한 도움말 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano Ultegra SM-BCR2 34 페이지. E-tube project
Shimano Ultegra SM-BCR2에 대해서도 마찬가지입니다: 도움말 매뉴얼 (32 페이지)
페이지 인쇄
4.
In the update content confirmation screen, check the content to be updated, and click [Update].
The update statuses displayed in the screen are as follows.
Update status
[Waiting for
update]
[Updating in
progress...]
[Normal end]
Make sure that the PC does not switch into standby while updating of the firmware is in
*
progress.
If the PC switches to standby, E-TUBE PROJECT processing will be interrupted and the screen
display will return to the main menu screen.
Do not disconnect the USB cable or the electric wires, remove the battery or turn off the
*
power for the PC while updating of the firmware is in progress.
When connecting the battery to carry out firmware updating, make sure that the battery is
*
sufficiently charged so that it does not run out of charge while updating of the firmware is in
progress.
If you click the [Cancel] button, updating of the firmware will be canceled. However, it will
*
not be canceled until updating of the firmware for the current unit has finished.
You cannot shut down the application while updating of the firmware is in progress.
*
5.
When updating of the firmware is complete, the firmware update complete screen will be
displayed, and the names of the units which were updated and their firmware versions will also
be displayed.
If an error occurs while updating firmware
If an error occurs during updating of the firmware, an error screen will be displayed.
The unit may not operate properly when it has failed to update the firmware. Do not use the unit in
that condition. Follow the on-screen instructions to restore the firmware.
Description
Units for which updating has not yet started
Unit for which updating is in progress
Units for which updating ended normally
EACH FUNCTION OF E-TUBE PROJECT
26 / 34