Siemens TOP WD 1200 작동 및 설치 지침 - 페이지 23

{카테고리_이름} Siemens TOP WD 1200에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens TOP WD 1200 28 페이지.

Align the machine

Fig. 8

! The machine must be perfectly level with all

four feet standing on the floor. It must not

rock from side to side.

Use a spirit level to align the machine on all

sides.

If necessary, correct the height of the machine s

feet.

1. Undo the lock nuts.

2. Adjust the height of the feet.

3. Tighten the lock nuts again firmly to ensure

that the feet remain at the same height.

Water supply - cold only

Fig. 19 , 21 , 22

For the water connection a standard cold-

water line with a minimum water pressure

of 0.1 MPa is required (with tap full ON, at

least 8 liters of water must flow out in one

minute). If the water pressure exceeds 1 MPa,

a pressure reducing valve must be added.

! Never connect the machine to the mixer tap

of a pressureless hot-water heater.

! Caution! Connections are under full water

pressure; check for leaks with tap turned

fully ON.

! The filters at the free end of the inlet hose

and at the back of the machine should only

be removed for cleaning purposes.

! To avoid water damage, the tap must be

turned OFF after using the machine.

! The plastic nuts on the hose connections

must only be tightened by hand.

The face of the water tap must be free

of burrs and sharp edges.