Siemens dishwasher 사용 설명서 - 페이지 22

{카테고리_이름} Siemens dishwasher에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens dishwasher 26 페이지. Dishwasher
Siemens dishwasher에 대해서도 마찬가지입니다: 사용 설명서 지침 (29 페이지), 사용 설명서 (30 페이지), 사용 설명서 (30 페이지), 사용 설명서 (30 페이지), 사용 설명서 (28 페이지), 사용 설명서 지침 (28 페이지), 사용 설명서 지침 (26 페이지), 사용 설명서 지침 (28 페이지), 사용 설명서 지침 (32 페이지), 사용 설명서 지침 (28 페이지), 사용 설명서 지침 (34 페이지), 사용 설명서 지침 (34 페이지), 사용 설명서 지침 (28 페이지), 사용 설명서 지침 (34 페이지), 사용 설명서 지침 (26 페이지), 사용 설명서 (40 페이지), 사용 설명서 지침 (31 페이지), 사용 설명서 지침 (40 페이지), 사용 설명서 (24 페이지), 사용 설명서 (28 페이지), 사용 설명서 (28 페이지)

페이지 인쇄
Siemens dishwasher 사용 설명서
en
– Some models:
The plastic housing on the water
connection contains an electric valve,
the connecting cables are in the supply
hose. Do not cut through this hose,
do not immerse the plastic housing in
water.

Delivery

Your dishwasher has been checked
thoroughly in the factory to ensure that it is
in working order. This may cause small
water stains. These will disappear after the
first wash cycle.

Technical specifications

Weight:
max. 27 kg
Voltage:
220–240 V, 50 Hz or 60 Hz
Connected load:
1.9–2.3 kW
Fuse:
10/16 A
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing valve
ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water; hot water max. temperature
60 °C.
22

Installation

The required installation dimensions can
be found in the installation instructions.
Level the appliance. Ensure that the
appliance is situated securely on the floor.
– The appliance can easily be installed in
a fitted kitchen between wooden and
plastic walls. If the plug is not freely
accessible, an allpole disconnector
with a contact opening of at least 3 mm
must be fitted on the installation side to
satisfy the relevant safety instructions.

Waste-water connection

– The required work sequence can be
found in the installation instructions. If
required, fit a siphon with an drainage
connection.
– Connect the waste-water hose to the
drainage connection of the siphon with
the enclosed parts.
Ensure that the drainage hose is not
kinked, crushed or twisted and that
there is no cover plate in the drainage
to prevent the waste water from flowing
out!

Fresh water connection

– Connect the fresh-water connection to
the tap according to the installation
instructions with the enclosed parts.
Ensure that the fresh-water connection
is not kinked, crushed or twisted.
– When replacing the appliance, always
use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing valve
ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water preferred; hot water max.
temperature 60 °C.