Siemens SN23E831TI 사용 설명서 - 페이지 30
{카테고리_이름} Siemens SN23E831TI에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SN23E831TI 40 페이지.
페이지 인쇄
en
Fault, what to do?
Fault
Detergent residue.
Water stains on plastic
parts.
Washable or water-soluble
coatings in the container or
on the door.
30
Cause
Detergent dispenser cover
blocked by utensils and therefore
does not open fully.
Detergent dispenser cover
blocked by the tablet.
Tablets used in the quick or short
programme.
Dissolving time of the detergent
is not reached in the selected
short programme.
Washing effect and dissolving
performance are reduced after a
prolonged storage time or
detergent is very lumpy.
Droplet formation on plastic
surface is physically unavoidable.
After drying, water stains are
visible.
Detergent substances are
deposited. These coatings cannot
usually be removed with
chemicals (appliance cleaner, ...).
If there is a "white coating" on the
container floor, the water
softening system has been set
marginally.
Salt dispenser cover 1J not
closed.
Only for glasses: Initial glass
corrosion – can only apparently
be wiped off.
Remedial action
Detergent dispenser cover must not be
obstructed by utensils.
Do not place utensils or fragrance dispenser
in the tablet collecting tray.
Tablet must be inserted flat and not upright.
Dissolving time of tablets too long for a
quick or short programme.
Use a detergent powder or select a more
intensive programme.
Change detergent.
Use a more intensive programme (more
water changes).
Arrange utensils in a sloping position.
Use rinse aid.
If required, increase softening setting.
Change detergent brand.
Clean appliance mechanically.
Increase softening setting and change
detergent if required.
Close salt dispenser cover correctly.
See "Glass and utensil damage".