Siemens ED FQ1 Series 사용 설명서 - 페이지 29
{카테고리_이름} Siemens ED FQ1 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens ED FQ1 Series 36 페이지. Induction hob with integrated ventilation system
Siemens ED FQ1 Series에 대해서도 마찬가지입니다: 사용 설명서 지침 (24 페이지)
페이지 인쇄
3Trouble shooting
U sually, faults are small matters that are easy to
T r o u b l e s h o o t i n g
eliminate. Please read the information in the table
before calling the after-sales service.
Display
None
The displays flash.
The
Ù
display flashes in the
cooking zone displays.
"
"ƒ
"...
"†
+ power level and audible
signal
"†
and audible signal
"‚
/
"‡
"‰
"Š‹‹‹
"Š‹‚‹
—...‹‹
Do not place hot cookware on the control panel.
Notes
If
appears on the display, press and hold the
"
■
button for the relevant cooking zone in order to read
the fault code.
If the fault code is not listed in the table, disconnect
■
the hob from the mains power supply and wait
30 seconds before reconnecting it. If this code is
displayed again, contact the technical after-sales
service and specify which fault code has appeared.
If a fault occurs, the appliance will not switch to
■
standby mode.
Possible cause
The power supply has been disconnected.
The appliance has not been connected as shown
in the circuit diagram.
Electronics fault.
The control panel is damp or there is something
on it.
A fault has occurred in the electronics.
The active carbon filter is saturated or the satura-
tion indicator lights up even though the filter has
been cleaned or replaced.
The electronics have overheated and have
switched off the affected cooking zone.
The electronics have overheated and all of the
cooking zones have been switched off.
There is hot cookware near the control panel.
There is a risk that the electronics will overheat.
There is hot cookware near the control panel.
The cooking zone has been switched off to pro-
tect the electronics.
The cooking zone has overheated and has been
switched off to protect the work surface.
The cooking zone has been operating continu-
ously for an extended period.
The operating voltage is incorrect and outside of
the normal operating range.
The hob is not connected correctly.
Solution
Use other electrical appliances to check whether a short circuit
has occurred in the power supply.
Ensure that the appliance has been connected as shown in the
circuit diagram.
If you are unable to rectify the fault, inform the technical after-
sales service.
Dry the control panel or remove the object.
To acknowledge the fault, briefly cover the control panel with
your hand.
Change the filter and reset the filter saturation indicator. You can
find additional information about this in section ~ "Cleaning".
Wait until the electronics have cooled down sufficiently. Then
touch any symbol on the hob.
Remove the cookware that is causing the problem. The fault dis-
play goes out shortly afterwards. You can continue cooking.
Remove the cookware that is causing the problem. Wait a few
seconds. Touch any touch control. When the fault indicator goes
out, you can continue cooking.
Wait until the electronics have cooled down sufficiently. Then
switch the cooking zone on again.
The automatic safety cut-out function has been activated. You can
find additional information about this in section .
Contact your electricity supplier.
Disconnect the hob from the mains. Ensure that the hob has been
connected as shown in the circuit diagram.
Trouble shooting
en
29