Ricoh Ri 3000 안전 정보 및 빠른 설치 매뉴얼 - 페이지 15
{카테고리_이름} Ricoh Ri 3000에 대한 안전 정보 및 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ricoh Ri 3000 24 페이지. Direct to garment printers
페이지 인쇄
Laws and Regulations
Legal Prohibition
Do not copy or print any item for which reproduction is prohibited by law.
Copying or printing the following items is generally prohibited by local law: bank notes, revenue stamps, bonds,
stock certificates, bank drafts, checks, passports, driver's licenses. The preceding list is meant as a guide only and
is not inclusive. We assume no responsibility for its completeness or accuracy. If you have any questions concerning
the legality of copying or printing certain items, consult with your legal advisor.
FCC Statement (USA):
•
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
•
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
•
Caution: Properly shielded and grounded cables and connectors must be used for connections to host
computer (and/or peripheral) in order to meet FCC emission limits.
Note to Users in California (USA):
•
Perchlorate
www.dtsc.ca.gov/hazardouswaste/perchlorate
Laser Emitter Warning and Laser Aperture Warning
•
The Obstruction Sensor detects any obstruction on the Print Table, such as wrinkles on the shirts, which can
damage the print heads. On the left-hand side of the printer, there is an Obstruction Laser Diode, which
generates the laser. On the right-hand side, there is the Obstruction Laser Sensor.
Laser(North America)
•
This equipment complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated
June 24, 2007 for class II laser product. This equipment contains one AlGaInP laser diode, 660 nanometer wavelength.
The beam divergence angle is 21 degrees (minimum) and 29 degrees (maximum) in the vertical direction, and 7 degrees
(minimum) and 11 degrees (maximum) in the horizontal direction, and laser beams are generated in Continuous Wave
(CW) mode. The maximum output power of the light source is 1 milliwatt.
•
WARNING: Although the laser used in the Ri 3000 and Ri 6000 printer is low power, exercise care so that laser
does not shine directly into the eyes. The laser can cause injury.
•
CAUTION—Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
•
Mangled Hand Warning: Keep body parts away from gears and moving parts.
•
Material
-
special
handling
13
may
apply.
See: