Cisco 2950 - Catalyst Switch 시작하기 매뉴얼 - 페이지 14
{카테고리_이름} Cisco 2950 - Catalyst Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2950 - Catalyst Switch 29 페이지. Long-reach ethernet switches
Cisco 2950 - Catalyst Switch에 대해서도 마찬가지입니다: 솔루션 매뉴얼 (17 페이지), 제품 게시판 (3 페이지), 제품 지원 게시판 (5 페이지), 마이그레이션 매뉴얼 (25 페이지), 제품 지원 게시판 (6 페이지), 데이터시트 (20 페이지), 매뉴얼 (19 페이지)
페이지 인쇄
Connect to the Switch Ports
This section describes how to connect to the fixed switch ports and to the SFP and GBIC module ports.
Connect to 10/100 and 10/100/1000 Ports
Follow these steps:
When you connect to servers,
Step 1
workstations, IP phones, wireless
access points, and routers, insert a
straight-through, twisted four-pair,
Category 5 cable in a switch 10/100 or
10/100/1000 port. Use a crossover,
twisted four-pair, Category 5 cable
when you connect to other switches,
hubs, or repeaters.
Step 2
Insert the other cable end into an RJ-45 connector on the other device.
Connect to 100BASE-FX and 1000BASE-SX Ports
Follow these steps:
Remove the dust plugs from the
Step 1
100BASE-FX or 1000BASE-SX port
and the rubber caps from the MT-RJ
patch cable. Store them for future use.
Insert an appropriate cable into a 100BASE-FX or 1000BASE-SX port. Insert the
Step 2
other cable end into an SC or ST port on the other device.
14
1
2
3
SY ST
4
1X
R PS
ST AT
U TI L
D U PL X
SP EE D
M O D E
2X
10/100 or 10/100/1000 ports
1
2
3
4
5
6
1X
7
8
9
10
11
12
13
2X
100BASE-FX or 1000BASE-SX ports
5
6
7
8
9
10
11
12
13
14
15
16
15 X
16 X
C a ta ly s t 2
9 5 0
14
SE RI ES
15
16
1 0 0 B a s e
-F X
15 X
2 5
2 6
16 X