Cisco 3800 Series 빠른 시작 매뉴얼 - 페이지 11

{카테고리_이름} Cisco 3800 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3800 Series 40 페이지. Password recovery procedure
Cisco 3800 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 문제 해결 매뉴얼 (15 페이지), 데이터시트 (20 페이지), 구성 (32 페이지), 사용자 설명서 (7 페이지)

페이지 인쇄

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

Warning

To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the handles on

modules (such as power supplies, fans, or cards); these types of handles are not designed to support the weight

of the unit. Statement 1032

Warning

This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260. Incorrectly

connecting this equipment to a general-purpose outlet could be hazardous. The telecommunications lines must be

disconnected 1) before unplugging the main power connector or 2) while the housing is open, or both.

Statement 1043

Warning

Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040

Warning

To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended

ambient temperature of 40 deg. Statement 1047

Installing the Router

You can install any Cisco 3800 series router in a rack. See the applicable instructions in the following sections.

Cisco 3800 series routers are normally ordered with modules and interface cards. Before you remove or install any

Note

modules or interface cards, see the documents that accompany those items or to the online Cisco 3800 series hardware

installation documentation at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/3800/hw/index.htm

For module and interface card compatibility information, see the data sheet for each module and interface card.

To prevent damage to the chassis, never attempt to lift or tilt the chassis by the plastic panel on the front. Always

Caution

hold the chassis by the metal body.

Rack-Mounting the Router

Cisco 3800 series routers can be installed in 19-inch (48.26-cm) racks. Use the standard brackets for mounting the chassis in a

19-inch (48.26-cm) rack.

If you choose to install your Cisco router in a 23-inch (58.42-cm) rack, you must acquire a 23-inch (58.42-cm) rack

Note

adapter from the rack manufacturer.

You can mount the router in the following ways:

• Center mounting—Brackets attached in the center of the chassis with the front panel facing forward

• Front mounting—Brackets attached at the front of the chassis with the front panel facing forward

• Rear mounting—Brackets attached at the rear of the chassis with the rear panel facing forward