Cisco 4000 Series 매뉴얼 - 페이지 16

{카테고리_이름} Cisco 4000 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 4000 Series 18 페이지. Upgrading memory
Cisco 4000 Series에 대해서도 마찬가지입니다: 설치 준비 (11 페이지), 설치 매뉴얼 (18 페이지), 교체 매뉴얼 (16 페이지), 업그레이드 매뉴얼 (24 페이지)

페이지 인쇄
Cisco 4000 Series 매뉴얼
Cisco RPS Support
DC
Cisco RPS
DC output
Fully Redundant Power
The Cisco RPS can provide a fully redundant power source for up to two Cisco 4000 series
routers. You can use a two-to-one cable to connect up to two external devices to the four
DC output power modules on the rear panel of the Cisco RPS, as shown in Figure 1-6. The
two-to-one cable is a Y-shaped cable with two connectors at one end of the cable and one
connector at the other end. Two connectors at one end of the Y-shaped cable connect to two
DC output power modules. The other end of the cable connects to one external device.
When using two-to-one cables, the power source is fully redundant because there are two
AC input modules and two DC output power modules connected to each external device. If
any power module fails, there is a full backup.
Figure 1-6
1-16 Cisco 4000 Series Installation Guide
DC
DC
External devices
150W or less
Fully Redundant Configuration
AC input
AC
AC
DC