Cisco WUMC710 사용자 설명서 - 페이지 7

{카테고리_이름} Cisco WUMC710에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WUMC710 17 페이지. 802.11ac
Cisco WUMC710에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (17 페이지), 사용자 설명서 (17 페이지)

페이지 인쇄

Linksys WUMC710

Advanced Configuration

Après avoir configuré le connecteur multimédia en suivant les étapes du

guide d'installation rapide, le connecteur multimédia est prêt à être utilisé

Cependant, si vous souhaitez modifier ses paramètres avancés, utilisez

l'utilitaire basé sur le navigateur Web du connecteur multimédia Le présent

chapitre explique chaque page Web de l'utilitaire et les principales options

proposées sur chacune Vous pouvez accéder à l'utilitaire depuis un navigateur

Web sur un ordinateur connecté au réseau du connecteur multimédia

The browser-based utility has these main tabs: Setup, Wireless, Administration,

and Status Additional tabs will be available after you click one of the main tabs

How to access the browser-based utility

Use a web browser to access the browser-based utility

If the media connector is connected to a network with a DHCP server (usually

the network router), then the media connector will obtain its IP address from

the DHCP server If there is no DHCP server, then the media connector will use

its default IP address, 10.100.1.1 (for example, if the media connector is not

connected wirelessly to any device but is connected directly to a computer

with an Ethernet cable) If you set a permanent static IP address on the media

connector through the browser-based utility, then enter the static IP address

instead

NOTE

If you do not know the media connector's IP address, then find its

IP address in the DHCP clients table of your router (Refer to the

documentation for your router )

If you cannot locate the media connector's IP address, you can reset

the media connector; press the Reset button on the media connector

for approximately five seconds, using a straightened paper clip This

will reset the media connector back to the factory default settings

The media connector will request an IP address from the DHCP server

(usually the network router) If no DHCP server is found (for example,

if the media connector is not connected wirelessly to any device but

is connected directly to a computer with an Ethernet cable), then the

media connector will use its default IP address, 10.100.1.1, until it

detects a DHCP server and is assigned a dynamic IP address

Launch your web browser, and enter the media connector's IP address (the

default setting is 10.100.1.1) in the Address field Press Enter

A password request screen appears (Non-Windows 7 users will see a similar

screen ) Leave the User name field blank Enter the password you created If you

did not create a new password, use the default password admin (You can set

a new password from the Administration > Management screen ) Click OK to

continue

NOTE

If the password request screen does not appear, wait two minutes

and try again

Advanced Configuration