Cisco Aironet 1570 Series 하드웨어 설치 매뉴얼 - 페이지 4

{카테고리_이름} Cisco Aironet 1570 Series에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1570 Series 10 페이지. Outdoor access point
Cisco Aironet 1570 Series에 대해서도 마찬가지입니다: 주문 매뉴얼 (17 페이지)

페이지 인쇄

FCC Safety Compliance Statement

When installing or replacing the unit, the ground connection must always be made first and

Warning

disconnected last. Statement 1046.

Warning

Do not locate the antenna near overhead power lines or other electric light or power circuits, or

where it can come into contact with such circuits. When installing the antenna, take extreme care

not to come into contact with such circuits, because they may cause serious injury or death. For

proper installation and grounding of the antenna, please refer to national and local codes (for

example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical

Code, Section 54). Statement 1052

Caution

Before connecting or disconnecting a power cord, you must remove power from the power cord using a

suitable service disconnect.

FCC Safety Compliance Statement

The FCC, with its action in ET Docket 96-8, has adopted a safety standard for human exposure to RF

electromagnetic energy emitted by FCC-certified equipment. When used with approved Cisco Aironet

antennas, Cisco Aironet products meet the uncontrolled environmental limits found in OET-65 and ANSI

C95.1, 1991. Proper operation of this radio device according to the instructions in this publication results

in user exposure substantially below the FCC recommended limits.

Safety Precautions

For safety and to achieve a good installation, please read and follow these safety precautions:

•

If an accident should occur, call for qualified emergency help immediately.

Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide

2-4

Select your installation site with safety, as well as performance in mind. Remember: electric power

lines and phone lines look alike. For safety, assume that any overhead line can kill.

Call your electric power company. Tell them your plans, and ask them to come look at your proposed

installation.

Plan your installation carefully and completely before you begin. Successful raising of a mast or

tower is largely a matter of coordination. Each person should be assigned to a specific task and

should know what to do and when to do it. One person should be in charge of the operation to issue

instructions and watch for signs of trouble.

When installing the access point and antennas, remember:

–

Do not use a metal ladder.

–

Do not work on a wet or windy day.

–

Do dress properly—shoes with rubber soles and heels, rubber gloves, long sleeved shirt or

jacket.

Use a rope to lift the access point. If the assembly starts to drop, get away from it and let it fall.

If any part of the antenna system should come in contact with a power line, do not touch it or try to

remove it yourself. Call your local power company. They will remove it safely.

Chapter 2

Preparing for Installation

OL-32138-01