Cisco WAP571 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} Cisco WAP571에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WAP571 15 페이지. Manually connect access points to the network via power over ethernet (poe)
Cisco WAP571에 대해서도 마찬가지입니다: 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (6 페이지)

페이지 인쇄
Cisco WAP571 빠른 시작 매뉴얼
Verify that the Cisco WAP571 is powered on and the lights indicate
S
1
TEP
the appropriate links.
Locate the device's IP address. While there are different ways to
S
2
TEP
locate your device's IP address, this procedure uses Cisco FindIT.
a.
If you have previously downloaded Cisco FindIT, open Internet
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see www.cisco.com/go/findit.
b. In the Cisco FindIT display, place your mouse over the device's
name. The device IP address is displayed along with other
device information.
Open a command window by choosing Start > Run and enter
S
3
TEP
cmd.
At the command window prompt, enter ping and the device IP
S
4
TEP
address. In this example, we pinged 192.0.2.10.
If successful, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128
If it fails, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Request timed out.
Possible Cause of Installation Failure
No Power
• Power up the switch and your computer if they are turned off.
• Make sure your PoE switch is powered on and the lights indicate that
you have a link. See
• Verify that the devices on your network are not plugged into a
switchable outlet.
Bad Ethernet Connection
• Check the state of the indicator lights. See
Installation, page
• Check the Ethernet cable to ensure that it is firmly connected to your
devices. Devices connected by the Ethernet cable can include the WAP
device, and routers, any switches, and your computer.
• Verify the connected switch has auto-negotiation enabled. The access
point and the switch need the same negotiation parameters set.
9
Verifying the Hardware Installation, page
6.
Verifying the Hardware
Cisco WAP571 Wireless Access Point
6.