CABINETS TO GO Findley & Myers VSB30DR 조립 지침 - 페이지 3
{카테고리_이름} CABINETS TO GO Findley & Myers VSB30DR에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CABINETS TO GO Findley & Myers VSB30DR 4 페이지. Vanity sink base w/drawer
페이지 인쇄
Instructions:
►
1.
Place the face frame (A) face down on a flat soft working surface to ensure that the face is
not scratched or damaged (Figure 1).
2.
Installing the Side Panels (Figure 2): Insert right and left side panels (B) into the grooves of
the face frame (A) and align the cam lock connectors (Figure 2). Lock the cam
with a screw driver by turning the screw 180° clockwise (Figure 4).
3.
Installing the Bottom (Figure 3): Gently spread the side panels and insert the bottom (C)
into the grooves of side panels (B) until it is seated in the face frame (A). Align it and lock each cam.
4.
Installing the Back Panel and Toe Kick (Figure 5): Before you start this step, place the back panel (D) on a flat surface facing
upward. Install the drawer rail holders (f) in the pre- spotted area on the back panel (Figure 6). Secure them with 2 flat head screws (e)
(Figure 6). Place the back panel (D) at rear of side panels (B.) Align and lock each cam lock. Install the Toe Kick (E) by locking the
cam lock at both ends (Figure 5).
e
f
Qty 8
Qty 4
5.
Drawer Assembly (Figure 7): First assemble the drawer front (A) with drawer box front (F)
with screws (d). Then assemble the rest of the parts of the drawer box (F) using your palm, or a
rubber mallet if needed, to secure the dove tails into position. Repeat step for 2nd drawer and set
them aside.
d
Qty 10
A
B
B
Figure 2
C
B
B
Figure 3
D
B
C
E
Figure 5
d
F
A
Figure 7
Page 3
Figure 1
f
D
F
Figure 4
e
Top
f