Cisco Codec C Series 시작하기 매뉴얼 - 페이지 30

{카테고리_이름} Cisco Codec C Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Codec C Series 35 페이지. Telepresence conference system
Cisco Codec C Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (41 페이지), 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (32 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (46 페이지)

페이지 인쇄

Cisco TelePresence Systems

GettinG started Guide

Table of contents

Introduction

Web interface

Setting the system/codec password

You need a username and password to sign in to the web

and command line interfaces of your system.

The video conference system is delivered with a default

user account with username

admin

and no password set.

This user has full access rights to the system.

NOTE: We strongly recommend that you set a password for

the

admin

user to restrict access to system configuration.

Make sure to keep a copy of the password in a safe

You have to contact your Cisco representative if you have

forgotten the password.

1. Go to the

Maintenance

tab and select

2. Enter the

Current

password, the

New

repeat the new password in the appropriate input fields.

The password format is a string with 0–64 characters.

If a password is not currently set, use a blank

password.

3. Click

Change

password.

User interfaces

Setting the Administrator Settings menu

password

When starting up the system for the first time the

Administrator Settings menu password is not set.

NOTE: We strongly recommend that you define a password

to protect the Administrator Settings menu, since these

settings affect the behavior of the video conference system.

The Administrator Settings menu password cannot be

set via the web interface. This has to be done using the

place.

command line interface or the remote control and on‑

screen menu.

Set the Administrator Settings menu password from

Change

Password.

a command line interface

password, and

1. Connect to the system through the network or the

serial data port, using a command line interface (SSH or

Telnet).

Current

2. Type the following command:

xCommand SystemUnit MenuPassword Set

Password: <password>

The password format is a string with 0–255 characters.

Set the Administrator Settings menu password

using the remote control and on-screen menu

1. Go to

Home > Settings > Administrator Settings > Set

password.

On the remote control, press the # key to toggle

between lower or upper case characters and numbers:

abc/ABC/123.

2. Enter the menu password. The password you enter is

hidden; each character is replaced with a star (*).

3. Select Save to save the changes, or Cancel to leave

without saving.

4. Press

Home

Configuration

Appendices

(

)

to exit.