Cisco TelePresence MX Series 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Cisco TelePresence MX Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence MX Series 41 페이지. Telepresence ex, mx, quick set c20, codec c, sx20 quick set, profile series video systems
Cisco TelePresence MX Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (42 페이지)

페이지 인쇄

Cisco TelePresence Video Systems

Contents

Configuration tasks (continued)

Setting the H.323 and SIP parameters

(when not set by a provisioning system)

To get online and ready to place and receive calls, your system

must be set up properly. Your system uses either the H.323

protocol or the SIP protocol for video calls.

Choose one of the following methods to set the H.323 and

SIP parameters:

Touch controller

Remote control

and on screen menu

Web interface

D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.

Introduction

User interfaces

Setting date and time

(when not set by a provisioning system)

When setting up your video conference system, you should

check that the date and time settings are correct. Among

other things this information is used to time stamp messages

transmitted to gatekeepers and other network elements.

Choose one of the following methods to set the date and time:

Touch controller

Remote control

and on screen menu

Web interface

Confirguration

Configuration

Setting the menu password

We strongly recommend that you set a password for the

Administrator Settings menu.

This menu, which is available on both the Touch controller and

the remote control, gives access to settings that affect the

behavior of the video conference system.

Choose one of the following methods to set-up the menu

password:

Getting Started Guide

Appendices

Remote control

and on screen menu

Web interface

Contacts