Cisco TelePresence Profile 55 시작하기 매뉴얼 - 페이지 28
{카테고리_이름} Cisco TelePresence Profile 55에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence Profile 55 42 페이지. Telepresence ex, mx, quick set c20, codec c, sx20 quick set, profile series video systems
Cisco TelePresence Profile 55에 대해서도 마찬가지입니다: 설치 (2 페이지), 시작하기 매뉴얼 (46 페이지)
페이지 인쇄
Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
Web interface
Setting the date, time and location
(when not set by a provisioning system)
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
If you operate your system using the Touch controller, the
time is shown in the top right corner of the Touch controller
display; if you operate your system using a remote control,
the time and date is shown in the top right corner of the
main display.
Back to task overview
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces
Configuration
Configuration
1. Go to the
Configuration
tab and select
Configuration.
Open the
Time
settings from the left column.
2. Select your preferred date format in the
drop down list.
3. Select your preferred time format in the
drop down list.
4. Select your time zone in the
5. Open the
NetworkServices
folder and then the
folder.
Select Auto,
Manual
or
Off
in the
If you select
Manual,
enter the NTP server address in the
Address
input field. Click
ok
to save the change.
If you select Off, you have to enter the time and date
manually using either the Touch controller
Settings > Administrator Settings > Date, Time &
Location) or the remote control and on-screen menu
system
(Home > Settings > Date and
NTP mode:
1
Auto:
The time is regularly updated using an NTP server. The
NTP server address is automatically obtained from the
network (DHCP).
Manual: The time is regularly updated using an NTP server. You
must manually enter the NTP server address.
Off:
You must set the time manually. The time will not be
updated automatically.
Appendices
Advanced
DateFormat
TimeFormat
Zone
drop down list.
NTP
Mode
drop down list.
1
(More >
Time).
28
www.cisco.com