ACU-RITE 06036 사용 설명서 - 페이지 10

{카테고리_이름} ACU-RITE 06036에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE 06036 20 페이지. Home environment display

Sync a New Monitor or Sensor with the Display

To manually add a new Monitor or Sensor to the display:

1. Press and release the color-coded button next to a location on the display with

the name "AVAILABLE." Next, "ADD MONITOR" will flash at the top of the

display.

2. Press the "SET" button. "SELECT MONITOR STYLE" and "

flash on the display.

3. Press and release the "▲" or "▼" buttons to highlight the icon that represents

the type of product you are adding.

4. Press the "SET" button to confirm your selection. "SELECT ID" appears on the

display.

5. Press and release the "▲" or "▼" buttons to cycle through the Monitors and/

or Sensors that the display has wirelessly identified.

6. Press the "SET" button to confirm your selection. "SELECT NAME" appears on

the display.

7. Press and release the "▲" or "▼" buttons to cycle through the available

location names. Select the name that most closely matches the location where

the Monitor or Sensor that is reporting data for the location is installed.

8. Press the "SET" button to confirm your selection.

The new Monitor or Sensor will now synchronize with the display. It may

take a few minutes for synchronization to complete. Please refer to the

troubleshooting section of this manual if anything appears to be functioning

improperly.

View Wired Sensor Readings

To toggle between Monitor and Wired Sensor readings:

1. Press and release the color-coded button for the corresponding location

containing the Wired Sensor to activate the location settings.

2. Press and release the same color-coded button again to toggle between

Monitor and Wired Sensor readings.

Move Location Data to a Different Position on the Display

The location data on the display can be moved to a different position on the

display. First, identify the two (2) data areas that you want to swap positions.

Press and HOLD the color-coded buttons found next to each area simultaneously

for 5 seconds. The data will switch positions on the display.

(if applicable)

" or "

" will