System Management Connections
The connections described in Table 4 provide system management access.
Table 4
System Management Connections
Port
Console
Auxiliary
Universal serial bus (USB)
6
Power Up the Router
To ensure adequate cooling, never operate the router unless the cover and all modules and cover plates are installed.
Caution
Checklist for Power-Up
You are ready to power up the Cisco 2800 series integrated services router after the following steps are completed:
• Chassis is securely mounted and grounded. (See the "Install Chassis" section on page 6.)
• Power and interface cables are connected. (See the "Connect Cables" section on page 19.)
• Make sure that the external CompactFlash memory card is properly seated into the slot. For installation instructions, see
the online Cisco 2800 series hardware installation documentation at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/2800/hw/index.htm
• PC with terminal emulation program is connected to the console port, powered up, and configured for 9600 baud, 8 data
bits, 1 stop bit, no flow control, and no parity. (See the "System Management Connections" section on page 28.)
• Suitable PC COM port is selected in the terminal emulation program.
For initial power-up, a direct console connection is recommended. After the initial configuration is completed, a remote
Note
modem connection can be used for router management.
To ensure adequate cooling, never operate the router unless the cover and all modules and cover plates are installed.
Caution
Caution
To prevent damage to the ejector mechanism, the ejector button next to the CompactFlash card must remain fully
seated when not being used to eject a CompactFlash card.
28
Color
Connection
Light blue
PC or ASCII terminal communication port
(usually labeled COM)
Black
Modem for remote access
—
Peripheral devices
Cable
RJ-45-to-DB-9 console cable
RJ-45-to-DB-25 modem cable
USB cable
페이지 인쇄