Sony PMW-100 사용 설명서 - 페이지 13

{카테고리_이름} Sony PMW-100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony PMW-100 31 페이지. Solid-state memory camcorder
Sony PMW-100에 대해서도 마찬가지입니다: 브로셔 및 사양 (8 페이지), 브로셔 및 사양 (6 페이지), 시작하기 (2 페이지), 사용 설명서 (32 페이지)

페이지 인쇄

Using AC Power (DC IN Power)

Connection example: when connecting BC-U1

Connect the DC power output cable of

the BC-U1 to the DC IN connector of

the camcorder.

Connect the power cord of the BC-U1 to

an AC power source.

Set the mode switch of the BC-U1 to the

DC OUT position.

Turning the Power On/Off

To turn the power on, set the power switch (page

8) to the ON position (the ? position). To turn the

power off, set the power switch to the OFF

position (the 1 position).

Notes

• This camcorder uses a little standby power even when

the power switch is set to OFF. Remove the battery

pack if the camcorder will not be used for a prolonged

period.

• When removing the battery pack or the DC IN power,

be sure to first set the power switch to the OFF

position. Removing the battery pack or the DC IN

power while the camcorder is ON may cause damage

to the camcorder or the SxS memory card.

Setting the Clock

When you turn the camcorder on for the first time

after purchasing or replacing the backup battery

("Appendices" in operating instructions (PDF)),

the Initial Setting display appears on the LCD

monitor/viewfinder screen.

Set the date and time of the built-in clock, using

this display.

Time Zone

The value shows the time difference from UTC

(Coordinated Universal Time).

Change the setting if needed.

Setting the time and date

Press the up/down/left/right buttons (page 9) or

turn the jog dial (page 10) to move the cursor,

BC-U1

then press the SEL/SET button or the jog dial to

set each menu item. When you press the SEL/

SET button or the jog dial when the cursor is on

"Finish," the Initial Setting display disappears,

the clock setting is completed, and the camcorder

enters the mode selected via the power switch.

After the Initial Setting display disappears, "Time

Zone" and "Clock Set" ("Menu Configuration

and Detailed Settings" in operating instructions

(PDF)) in the OTHERS menu can be used to set

"Time Zone" and "Date/Time."

Notes

• If the clock setting is cleared because of exhaustion of

the backup battery while no operation power was being

supplied (no battery pack and no DC IN connection),

the Initial Setting display will be displayed when you

turn the camcorder on at the next opportunity.

• While the Initial Setting display is shown, no other

operation except turning the power off is permitted

until you finish the setting for this display.

Setting the Clock