Cisco ASA 5506-X 설치 매뉴얼 - 페이지 15

{카테고리_이름} Cisco ASA 5506-X에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506-X 46 페이지. Threat defense reimage guide
Cisco ASA 5506-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (12 페이지), 섀시 마운트 (10 페이지), 하드웨어 설치 매뉴얼 (26 페이지)

Overview

Internal and External Flash Storage

The ASA contains one internal USB flash drive, and a standard USB Type A port that you can use to attach

an external device. The USB port can provide output power of 5 volts, up to a maximum of 500 mA (5 USB

power units).

Internal USB Device

External USB Drive (Optional)

FAT-32 File System

The ASA 5506-X and ASA 5506W-X ship with an SSD installed that provides storage support. The SSD has

50 GB of useable space and is not field-replaceable. You must return the entire ASA to Cisco for drive

replacement. The SSD is used by the software; there is no user access to the SSD.

The ASA 5506H-X ships with a ruggedized SSD installed that provides storage support. The SSD is an

industrial-rated part so that it operates over the extended temperature range that the ASA 5506H-X supports.

The SSD has 50 GB of useable space and is not field-replaceable. You must return the entire ASA to Cisco

for drive replacement. The SSD is used by the software; there is no user access to the SSD.

The ASA 5506-X and ASA 5506W-X ship with a 12V brick power supply that provides 60 W.

The ASA 5506H-X ships with a ruggedized 5V-5.3V barrel power supply that provides 22 W. The power

supply supports an extended temperature range of -25°C to 60°C. Or you can order an optional DC power

supply that supplies 24V DC (part number PWR2-20W-24VDC) or 20W 20-60V DC (part number

PWR2-22W-20-60VDC).

The following table contains hardware specifications for the ASA.

Online Only

An embedded eUSB device is used as the internal flash; it is identified as disk0.

You can use the external Type A USB port to attach a data-storage device. The external USB drive

identifier is disk1. When the ASA is powered on, a connected USB drive is mounted as disk1 and is

available for you to use. Additionally, the file-system commands that are available to disk0 are also

available to disk1, including copy, format, delete, mkdir, pwd, cd, and so on.

If you insert a USB drive with more than one partition, only the first partition is mounted.

The ASA only supports FAT-32-formatted file systems for the internal eUSB and external USB drives.

If you insert an external USB drive that is not in FAT-32 format, the system mounting process fails, and

you receive an error message. You can enter the command format disk1: to format the partition to

FAT-32 and mount the partition to disk1 again; however, data might be lost.

Cisco ASA 5506-X, ASA 5506W-X, and ASA 5506H-X Hardware Installation Guide

Internal and External Flash Storage