Cisco Catalyst 2960-XR 시작하기 매뉴얼 - 페이지 19

{카테고리_이름} Cisco Catalyst 2960-XR에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 2960-XR 25 페이지.
Cisco Catalyst 2960-XR에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (34 페이지), 하드웨어 매뉴얼 (20 페이지)

페이지 인쇄

Front-mounting position

Connecting the FlexStack Cables (Optional)

Always use a Cisco-approved FlexStack cable to connect the switches.

This is only supported on the stack-capable switches.

Note

Use only approved cables, and connect only to other Catalyst 2960-X or 2960-S switches. Equipment

Caution

might be damaged if connected to other nonapproved Cisco cables or equipment.

Procedure

Step 1

Remove the dust covers from the FlexStack cables, and store them for future use.

Step 2

Insert one end of the FlexStack cable into the stack port of the first switch. Insert the other end of the cable into the stack

port on the other switch. Make sure that you insert the cables in completely until you feel them snap into place.

When you connect the FlexStack cable to the STACK 1 port, the tab should be above the connector. When you

Note

connect the FlexStack cable to the STACK 2 port, the tab should be below the connector.

Rear-mounting position