Cisco Physical Access 1125 Appliance 사용자 설명서 - 페이지 38

{카테고리_이름} Cisco Physical Access 1125 Appliance에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Physical Access 1125 Appliance 42 페이지.

Connecting to the AC Power Source

Warning

This equipment must be grounded. Never defeat the ground conductor or

absence of a suitably installed ground conductor.

or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Connect the AC power receptacle to the AC power source with the provided power cable.

Use unshielded twisted-pair (UTP,) copper-wire Ethernet cable, with standard RJ-45-compatible plugs,

to connect the Cisco PAM to the network.

To connect the cables:

Plug the Ethernet network connection into port ETH 1. See

Step 1

the Ethernet ports.

If a redundant standby appliance is installed, connect the supplied serial cable between the serial ports

Step 2

on each appliance. See

Do not work on the system or connect or disconnect cables during periods of lightning activity.

Warning

Configure the Cisco PAM server software as described in the

Guide.

Cisco Physical Access 1125 Appliance User Guide

3-20

Figure 1-3 on page 1-3

for the location of the serial port.

Chapter 3

Rack Mounting the Cisco PAM 1125 Appliance

operate the equipment in the

Contact the appropriate electrical inspection authority

Figure 1-3 on page 1-3

Cisco Physical Access Manager User

for the location of

OL-20929-01