Cisco PIX 506E 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} Cisco PIX 506E에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco PIX 506E 17 페이지. Chapter 3
Cisco PIX 506E에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (18 페이지), 사용자 설명서 (8 페이지)

페이지 인쇄

Alternative Ways to Access the PIX 506E

You can access the command-line interface (CLI) for administration using the console port on the PIX

Firewall. To do so, you must run a serial terminal emulator on a PC or workstation.

AC T

LI NK

ET HE RN

ET 1

PC terminal adapter

To connect a console for local administrative access:

Plug one end of the console cable adapter into a standard 9-pin PC serial port.

Step 1

Plug one end of the blue console cable (72-1259-01) into the PC terminal adapter.

Step 2

Plug the other end of the blue console cable into the Console port.

Step 3

Step 4

Configure the PC terminal emulation software or terminal for 9600 baud, 8 data bits, no

parity, and 1 stop bit.

You can also access the CLI using SSH/Telnet to the PIX Firewall. By default, SSH/Telnet access is not

permitted. Use PDM or the console to configure SSH/Telnet access to the PIX Firewall. To Telnet to

the PIX Firewall from the outside perimeter of the firewall, configure an outside IP address and IPSec

for a secure Telnet session. Refer to the Cisco PIX Firewall and VPN Configuration Guide for more

information about how to use the command-line interface (CLI).

AC T

PO W ER

LI NK

IN PU T

ET HE RN

PO W ER

ET 0

IN PU T

US B

CO NS O LE

Cisco PIX 506E

Blue console cable