Cisco SCE 1000 and 빠른 시작 매뉴얼 - 페이지 35

{카테고리_이름} Cisco SCE 1000 and에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE 1000 and 49 페이지. Service control engine 1000 2xgbe

Cable the Line Ports

This section provides instructions for cabling the Gigabit Ethernet ports and for configuring Gigabit Ethernet (GBE) interface

parameters.

Note

When installing an External Optical Bypass module, the SCE 1000 line ports are connected to the module. See

Optical Bypass

Module" in the

instructions.

• Information About Cabling, page 35

• Cabling the Line Interfaces, page 36

Information About Cabling

• Single Link: Inline Topology, page 35

• Single Link: Receive-only Topology, page 36

Single Link: Inline Topology

In the inline or bump-in-the-wire topology, illustrated in the diagram bellow, the SCE 1000 resides physically on the data link

between the subscriber side, usually either a BRAS (in DSL access), a PDSN (in wireless access), a CMTS (in the Cable access),

or a switch or router aggregator (in other topologies), and the network side, usually a router or layer 3 switch network element.

This is the inline topology, providing both traffic monitoring and control capabilities.

In this topology, all the traffic of the SCE 1000 is deployed as a transparent layer2 overlay on the customer's existing network.

Figure 16

Bump-in-the-Wire Installation

PWR A

PWR B

STATUS

BYPASS

Subscriber

Router/Switch

Subscriber

Cisco SCE 1000 2xGBE Installation and Configuration Guide

LINK RX TX

GBE-1

SUB

LINE

NET

Network

Cisco SCE 1000

2xGBE

Network

Router/Switch

for complete

Series

"External