Cisco SCE 1000 and 빠른 시작 매뉴얼 - 페이지 44

{카테고리_이름} Cisco SCE 1000 and에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE 1000 and 49 페이지. Service control engine 1000 2xgbe

Identifying Startup Problems

Startup problems are commonly due to the source power or to a poor cable connection.

This section contains a detailed description of the normal startup sequence and describes the steps to take if the system does not

perform that sequence as expected. LEDs indicate all system states in the startup sequence. By checking the state of the LEDs,

you can determine when and where the system failed in the startup sequence. Use the following descriptions to isolate the

problem to a subsystem, and then proceed to the appropriate sections to try to resolve the problem.

When you start up the system by turning on the power supply switch, the following should occur:

• You should immediately hear the fans operating.

• When all LEDs come on to indicate that the system has booted successfully, the initial system banner should be displayed

on the console screen. If it is not displayed, see Connect the Local Console, page 13 to verify that the terminal is set correctly

and that it is properly connected to the console port.

• If the banner is displayed, but the Status LED is flashing orange, indicating a warning state, check the user log:

At the prompt, type:

• If any of the following warning messages appear, turn the SCE 1000 platform off and call technical support.

"voltage problem"

–

"fans problem"

–

"abnormal raise in interior temperature"

–

• If the following warning message appears, delete unneeded files from the disk.

"insufficient disk space:"

–

Use the following commands to provide information to help you troubleshoot installation of your SCE 1000 platform. Refer to

Cisco SCE 2000 and SCE 1000 Software Configuration Guide

for more information.

Remember that if the management interface is not operational, you should connect the SCE 1000 platform to a local

Note

console so that you can enter CLI commands for troubleshooting.

• Troubleshooting firmware package installation:

boot system <filename>— Specifies and verifies the package file to be installed. Error messages or other output identify

–

problems with the package file.

Following is a sample output from the boot system command.

SCE 1000(config)#boot system ftp://vk:[email protected]/downloads/SENum.pkg.pkg

Verifying package file SENum.pkg.pkg...

Package file verified OK.

more user log

or the

Cisco SCE 2000 and SCE 1000 CLI Command Reference