Cisco SCE8000 GBE 제거 및 교체 절차 - 페이지 4

{카테고리_이름} Cisco SCE8000 GBE에 대한 제거 및 교체 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SCE8000 GBE 36 페이지. 10gbe platform
Cisco SCE8000 GBE에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (25 페이지), 구성 매뉴얼 (18 페이지), 설치 (21 페이지)

페이지 인쇄

Removing and Replacing the Power Supply

This section describes how to remove and install power supplies for the Cisco SCE 8000.

In systems with redundant power supplies, you can replace the faulty supply while the system is

Note

operating.

This section contains the following information:

•

Required Tools

A flat-blade or number 2 Phillips-head screwdriver is required to perform these procedures.

Additionally, a wire cutter or scissors may be necessary for cutting cable tie-wraps.

Removing an AC-Input Power Supply

Warning

Hazardous voltage or energy is present on the backplane when the system is operating. Use caution

when servicing.

Statement 1034

Turn the power switch to the Off (0) position on the power supply you are removing.

Step 1

Disconnect the power cord from the power source. Do not touch the metal prongs on the power cord

Step 2

when it is still connected to the power supply.

Remove the power cord from the power connection on the power supply module. Do not touch the metal

Step 3

prongs embedded in the power supply.

Cisco SCE8000 10GBE Installation and Configuration Guide

9-4

Required Tools, page 9-4

Removing an AC-Input Power Supply, page 9-4

Installing an AC-Input Power Supply, page 9-6

Removing a DC-Input Power Supply, page 9-6

Installing a DC-Input Power Supply, page 9-8

Chapter 9 Removal and Replacement Procedures

OL-26784-02