Cisco SG 100D-08 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Cisco SG 100D-08에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SG 100D-08 8 페이지. Unmanaged gigabit switch with qos
Cisco SG 100D-08에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (13 페이지)

페이지 인쇄

Mounting the Cisco

Unmanaged Desktop Switch

The unmanaged desktop switch can be placed on a flat surface or

mounted on a wall. Do not deploy the device in a location where any of the

following conditions exist:

High Ambient Temperature—The ambient temperature must not

exceed 104 degrees Fahrenheit (40 degrees Centigrade).

Reduced Air Flow—Both side panels must be unobstructed to prevent

overheating.

Mechanical Overloading—The device should be level, stable, and

secure to avoid it sliding or shifting out of position.

Circuit Overloading—Adding the device to the power outlet must not

overload that circuit.

Wall Mounting

If you plan to mount this switch to a wall, you need 2 wallboard screws to

mount the unmanaged desktop switch to the wall. We recommend using

screws with a minimum of 0. 1 7 inches (4.3 mm) width at the head and at

least 0.55 inches (14.0 mm) long. Depending on your mounting surface, you

might require longer screws or drywall anchors with a minimum of 0.30

inches (7.6 mm) width at the head and at least 0.59 inches (15.0 mm) long.

Cisco is not responsible for damages incurred by insecure wall-

ARNING

mounting.

To mount the unmanaged desktop switch to the wall:

Determine where you want to mount the unmanaged desktop

TEP

switch. Verify that the surface is smooth, flat, dry, and sturdy.

Drill two pilot holes into the wall surface. The distance between the

TEP

screws should be:

•

Cisco SF 100D-05 = 1.70 in (43.0 mm)

•

Cisco SF 100D-08, Cisco SF 100D-16, and

Cisco SG 100D-08 = 2.58 in (63.5 mm)

Unmanaged Desktop Switch