Cisco VIP4-50= 설치 및 구성 매뉴얼 - 페이지 37

{카테고리_이름} Cisco VIP4-50=에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco VIP4-50= 44 페이지. Fourth generation versatile interface processor

페이지 인쇄

1. Vip4 Overview

Figure 10

Note: You must first remove the

VIP from the chassis before

removing a port adapter from the

VIP4.

Step 1

To remove the port adapter,

remove

the screw that secures the port

adapter (or blank port adapter).

(See A.)

Step 2

With the screw removed, grasp

the handle on the front of the port

adapter (or blank port adapter)

and carefully pull it out of its slot,

away from the edge connector at

the rear of the slot. (See A.)

Step 3

To insert the port adapter,

carefully align the port adapter

carrier between the upper and

the lower edges of the port

adapter slot. (See B.)

Step 4

Install the screw in the rear of the

port adapter slot. Do not overtighten

the screw. (See A.)

Step 5

Carefully slide the new port adapter

into the port adapter slot until the

connector on the port adapter is

completely seated in the connector

at the rear of the port adapter slot.

(See B.)

Step 6

Reinstall the VIP motherboard in the

chassis, and tighten the captive

installation screw on each end of the

VIP faceplate. (See C.)

Dual-Width Port Adapter

Dual-width port adapters occupy both port adapter slots on a VIP4. Before you can install a dual-width

port adapter, you must first remove the slot divider that is located between the two port adapter slots.

(See

OL-3673-01

Removing and Installing a Single-Width Port Adapter

Figure

11.) Refer to

Table 5

Fourth Generation Versatile Interface Processor (VIP4) Installation and Configuration Guide

Screw

for a list of dual-width port adapters.

VIP4 Maintenance Procedures

Carrier

Upper edge

Lower edge

Captive

installation

screw