Cisco Firepower 2130 시작하기 - 페이지 12

{카테고리_이름} Cisco Firepower 2130에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 2130 42 페이지. Rack-mount and ground the chassis
Cisco Firepower 2130에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지), 배포 매뉴얼 (8 페이지), 설치 및 유지 관리 (26 페이지)

페이지 인쇄

Connect the Interfaces

Before you begin

Before you start the initial setup, the device includes some default settings. For details, see

Prior to Initial Setup, on page

Procedure

Step 1

Connect the Interfaces, on page 12

Step 2

Complete the Initial Configuration Using the Setup Wizard, on page 23

For details about the resulting configuration, see

Connect the Interfaces

The default configuration assumes that certain interfaces are used for the inside and outside networks. Initial

configuration will be easier to complete if you connect network cables to the interfaces based on these

expectations.

The default configuration for most models is designed to let you attach your management computer to the

inside interface. Alternatively, you can also directly attach your workstation to the Management port. The

interfaces are on different networks, so do not try to connect any of the inside interfaces and the Management

port to the same network.

Do not connect any of the inside interfaces to a network that has an active DHCP server. This will conflict

with the DHCP server already running on the inside interface . If you want to use a different DHCP server

for the network, disable the unwanted DHCP server after initial setup.

The following topics show how to cable the system for this topology when using the inside interfaces to

configure the device.

Getting Started

26.

Configuration After Initial Setup, on page

Getting Started

Default Configuration

29.