Cisco UCS B22 M3 설치 및 서비스 참고 사항 - 페이지 4

{카테고리_이름} Cisco UCS B22 M3에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B22 M3 31 페이지. Blade server
Cisco UCS B22 M3에 대해서도 마찬가지입니다: 업그레이드 매뉴얼 (21 페이지)

페이지 인쇄

LED

Health

(Disk Drive)

Buttons

The Reset button is recessed in the front panel of the server. You can press the button with the tip of a paper clip or a similar item.

Hold the button down for five seconds, and then release it to restart the server if other methods of restarting do not work.

The locator function for an individual server may get turned on or off by pressing the locator button/LED.

The power button allows you to manually take a server temporarily out of service but leave it in a state where it can be restarted

quickly. If the desired power state for a service profile associated with a blade server is set to "off," using the power button or Cisco

UCS Manager to reset the server will cause the desired power state of the server to become out of sync with the actual power state

and the server may unexpectedly shut down at a later time. To safely reboot a server from a power-down state, use the Boot Server

action in Cisco UCS Manager.

Local Console Connector

The local console connector allows a direct connection to a blade server to allow operating system installation and other management

tasks to be done directly rather than remotely. The port uses the KVM dongle cable that provides a connection into a Cisco UCS

blade server; it has a DB9 serial connector, a VGA connector for a monitor, and dual USB ports for a keyboard and mouse. With this

cable, you can create a direct connection to the operating system and the BIOS running on a blade server. A KVM cable ships standard

with each blade chassis accessory kit.

Figure 2: KVM Cable for Blade Servers

Connector to blade server local console

connector

Color

Description

Off

Can mean either no fault detected or the drive is not installed.

Flashing Amber

Rebuild drive active. If the Activity LED is also flashing amber, a

4 hz

drive rebuild is in progress.

Amber

Fault detected.

VGA connection for a monitor