Cisco UCS E Series 문제 해결 매뉴얼 - 페이지 3

{카테고리_이름} Cisco UCS E Series에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS E Series 28 페이지. Ucs e series unified computing system
Cisco UCS E Series에 대해서도 마찬가지입니다: 제품 개요 (8 페이지), 설치 매뉴얼 (46 페이지)

페이지 인쇄

Overview

The SD0 card is the lower card, located in the bottom SD card slot.

Note

Figure 2: Front Panel of the Double-Wide E-Series Server

• Power down the E-Series Server to check whether the SD card has come out of the slot. If it has, reinsert

Do not remove the SD card when the system is in operation.

Note

CIMC Upgrade Fails When Upgrading from Version 2.2 to 3.1.x

If you are running CIMC version 2.2.x, first upgrade to version 2.3.2 and then upgrade to 3.1.x.

If you have already upgraded to CIMC version 3.1.x, type *** to get into the recovery shell and then install

the image 3.1.x from the recovery shell.

Cannot Download the Host Image

To resolve this problem, verify the following:

• The FTP server on which you want to download the host image is running.

• The FTP server path to the image files is correct.

Cannot Power on the E-Series Server

To resolve this problem, clear the server's BIOS CMOS memory using the CIMC GUI or the CIMC CLI:

Clearing the BIOS CMOS Using the CIMC GUI

Before You Begin

• Log into the CIMC GUI as a user with admin privileges.

• Power off the server.

the SD card. Do the following:

◦ If the E-Series Server is installed in a Cisco 3900 series router, use the hw-module sm slot oir-stop

command to power down the server, reinsert the SD card, and then use the hw-module sm slot

oir-start command to start the server.

◦ If the E-Series Server is installed in a Cisco 2900 series router, power cycle the router.

Troubleshooting Guide for Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine

General Troubleshooting