Cisco C1100TG-1N32A 하드웨어 설치 매뉴얼 - 페이지 21

{카테고리_이름} Cisco C1100TG-1N32A에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco C1100TG-1N32A 44 페이지. Terminal gateway

Prepare for Router Installation

See the following online document for more information about network connections and interfaces:

• Cisco Modular Access Router CableSpecifications

Ethernet Connection

Note

To reduce the risk of electric shock, the following ports must be connected through an approved network

termination unit with integral circuit protection if the port cabling is routed outdoors: ethernet. Statement 1044

The IEEE has established Ethernet as standard IEEE 802.3. The routers support the following Ethernet

implementations:

• 1000BASE-T—1000Mb/s full-duplex transmission over a Category 5 or better unshielded twisted-pair

• 100BASE-T—100 Mb/s full-duplex transmission over a Category 5 or better unshieldedtwisted-pair

• 10BASE-T—10Mb/s full-duplex transmission over a Category 5 or better unshielded twisted-pair (UTP)

See the Cisco Modular Access Router Cable Specifications document at Cisco.com for information about

Ethernet cables, connectors, and pinouts

You need the following tools and equipment to install and upgrade the router and its components:

• ESD-preventive cord and wriststrap

• Number 2 Phillipsscrewdriver

• Phillips screwdrivers: small, 3/16-in. (4 to 5 mm) and medium, 1/4-in. (6 to 7mm)

• To install or removemodules

• Screws that fit yourrack

• Wire crimper

• Wire for connecting the chassis to an earthground:

(UTP) cable. Supports the Ethernet maximum length of 328 feet (100 meters).

cable. Supports the Ethernet maximum length of 328 feet (100 meters).

• 6 AWG

Hardware Installation Guide for the Cisco 1100 Terminal Gateway

Ethernet Connection