Cisco Firepower 1600 하드웨어 설치 매뉴얼 - 페이지 27
{카테고리_이름} Cisco Firepower 1600에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 1600 44 페이지.
페이지 인쇄
Installation Preparation
•
•
•
•
•
•
•
Installation Warnings
Be sure to read the REGULATORY & COMPLIANCE SAFETY INFORMATION document before installing
the Firepower Management Center management appliance.
Caution
Do NOT open the appliance except under direction from TAC.
Take note of the following warnings:
Warning
Statement 1071-Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Warning
Statement 1005-Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: USA: 120 V, 15 A (EU: 250 V, 16 A)
Installation Warnings, on page 23
Safety Recommendations, on page 25
Maintain Safety with Electricity, on page 25
Prevent ESD Damage, on page 26
Site Environment, on page 26
Power Supply Considerations, on page 26
Rack Configuration Considerations, on page 27
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
2
C H A P T E R
23