Cisco IC3000 하드웨어 설치 매뉴얼 - 페이지 16
{카테고리_이름} Cisco IC3000에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IC3000 37 페이지. Industrial compute gateway
Cisco IC3000에 대해서도 마찬가지입니다: 제품 문서 (12 페이지)
페이지 인쇄
Reset Button
Reset Button
The Reset button resets the device configuration to the default configuration set by the factory. To restore the
configuration to the default configuration set by the factory, use a standard size #1 paper clip with wire gauge
0.033 inch or smaller and press the reset button for 5 seconds.
Power Supply
The Cisco IC3000 comes with redundant external power connector. the connector supports 12 - 48 VDC. The
connectors are Molex 5.00mm Pitch Eurostyle
The power supply does not support reverse polarity, but does have reverse polarity protection. This means if
you reverse + & - connections, the system will not power on but there will be no damage.
The + terminal always has to be greater than the - terminal for the system to operate. The difference is in the
system grounding scheme used.
The IC3000 supports 3 basic schemes:
• Isolated DC in, neither + nor - terminal is tied to chassis GND
• Positive DC in, negative (-) terminal is tied to chassis GND
• Negative DC in, positive (+) terminal is tied to chassis GND
Note: To ensure uninterrupted operation the redundant power connections must be connected to independently
separated power sources.
SFP Support
The Cisco IC3000 has 2 1GbE ports which support the following SFPs:
• GLC-SX-MM-RGD
• GLC-LX-SM-RGD
• GLC-FE-100LX-RGD
• GLC-FE-100FX-RGD
Removable SD Flash Memory Card (optional)
The Cisco IC3000 has an optional removable SD flash memory slot (referred to as SD). This is primarily to
allow easy updates, copying of logs and crash-dumps. Contact your Cisco Marketing Representative for
ordering information.
Installing or Removing the SD Card (Optional)
The SD card is hidden under a protective cover:
Cisco IC3000 Industrial Compute Gateway Hardware Installation Guide
14
™
Horizontal Plug, with Retention Screws.
Product Overview