Cisco IC3000 하드웨어 설치 매뉴얼 - 페이지 21
{카테고리_이름} Cisco IC3000에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IC3000 37 페이지. Industrial compute gateway
Cisco IC3000에 대해서도 마찬가지입니다: 제품 문서 (12 페이지)
페이지 인쇄
Installing the Cisco IC3000 Industrial Compute Gateway
Figure 3: IC3000 Rear Din Mount
To attach the Cisco IC3000 to a DIN rail, follow these steps.
1. Position the rear panel of the device directly in front of the DIN rail, making sure that the DIN rail fits in
the space between the two hooks near the top of the device and the spring-loaded latch near the bottom.
2. Holding the bottom of the device away from the DIN rail, place the two hooks (1) on the back of the
device over the top of the DIN rail.
3. Push the device toward the DIN rail to cause the spring-loaded latch (2) at the bottom rear of the device
to move down, and snap into place.
Removing the Device from a DIN Rail
To remove the device from a DIN rail, follow these steps:
1. Ensure that power is removed from the device, and disconnect all cables and connectors from the front
panel of the device.
2. Insert a tool such as a flathead screwdriver in the slot at the bottom of the spring-loaded latch (3) and use
it to release the latch from the DIN rail.
3. Pull the bottom of the device away from the DIN rail, and lift the hooks off the top of the DIN rail.
Cisco IC3000 Industrial Compute Gateway Hardware Installation Guide
Removing the Device from a DIN Rail
19