Cisco IC3000 하드웨어 설치 매뉴얼 - 페이지 27
{카테고리_이름} Cisco IC3000에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IC3000 37 페이지. Industrial compute gateway
Cisco IC3000에 대해서도 마찬가지입니다: 제품 문서 (12 페이지)
페이지 인쇄
Connecting the Cisco IC3000
Figure 8: mini-USB Cover
Step 3
Connect the mini-USB side of a cable to the USB Console port on the Cisco IC3000.
Step 4
Connect the opposite end of the mini-USB cable to the USB port on your PC. If your PC warns you that you do not have
the proper drivers to communicate with the device, you can obtain them from your computers manufacturer, or go here:
https://software.cisco.com/download/home/282774227/type/282855122/release/3.1
Step 5
Start up a console terminal.
Connecting to DC Power
Before you begin
WARNING: Before performing any of the following procedures, ensure that power is removed from the DC
circuit. Statement 1003
WARNING: This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure
that the protective device is rated not greater than 60 VDC minimum, 5A maximum. Statement 1005
WARNING: A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Statement 1022
WARNING: Only trained and qualified personnel should be allowed to install, replace, or service this
equipment. Statement 1030
Cisco IC3000 Industrial Compute Gateway Hardware Installation Guide
Connecting to DC Power
25