Cisco Linksys WAG310G 사용자 설명서 - 페이지 6
{카테고리_이름} Cisco Linksys WAG310G에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Linksys WAG310G 39 페이지. Wireless-g adsl2+ iad gateway
페이지 인쇄
Chapter1
W-F Protected Setup
devices, such as a wireless adapter, that supports
Wi-Fi Protected Setup, then you can use Wi-Fi
Protected Setup to automatically configure
wireless security for your wireless network(s).
If your client device has a Wi-Fi Protected Setup
button, click or press that button. Then click the
W-F Protected Setup button on the Gateway's
top panel.
If your client device asks for the Gateway's PIN
number, enter this number: 88888888 on your
client device.
The Wi-Fi Protected Setup process is automatic.
NOTE:
You can also use the Wi-Fi
Protected Setup feature through
the Wireless > Basic Wireless Settings
screen of the Gateway's web-based
utility.
Back Panel
DSL
The DSL port connects to the ADSL line.
Lne
The Line port connects to the Public
Switch Telephone Network (PSTN).
Phone 1-2
The Phone ports connect standard
analog telephones to the Gateway.
USB
The USB port connects to a USB device.
Ethernet WAN/LAN5
act as a WAN (Internet) or LAN (local network)
port. As a WAN port, it connects to a broadband
modem. As a LAN port, it connects to a wired
computer or other Ethernet network device.
Ethernet LAN 1-
3, 4) connect the Gateway to wired computers
and other Ethernet network devices.
Power Swtch
Use this switch to power on or
off the Gateway.
Power
The Power port is where you will
connect the power adapter.
Wreless-G ADSL2+ IAD Gateway
If you have client
The WAN/LAN5 port can
These Ethernet ports (1, 2,
Product Overview
Reset
There are two ways to reset the Gateway's
factory defaults. Either press and hold the Reset
button for approximately five seconds, or restore
the defaults from the Administration > Factory
Defaults screen of the Gateway's web-based
utility.
NOTE:
To safely wall mount this unit,
the side panel with antenna must face
upward.
5