Cisco TelePresence ISDN GW MSE 8321 시작하기 - 페이지 10
{카테고리_이름} Cisco TelePresence ISDN GW MSE 8321에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence ISDN GW MSE 8321 17 페이지.
Cisco TelePresence ISDN GW MSE 8321에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (15 페이지)
페이지 인쇄
Initial configuration
Step one: Configure Ethernet Port A settings
The default setting for the ISDN gateway Ethernet ports is auto-sensing mode. If the
switch ports to which you connect the ISDN gateway are not also set to auto-sensing
mode, then you need to configure the ISDN gateway Ethernet ports to use the same
speed and duplex mode.
Only connect to Ethernet Port A, as all initial configuration must be done
i
on this port. Do not connect anything to Ethernet Port B.
Both ends of the Ethernet connection must be configured in the same
i
way. For example, either configure both ends of the link to be auto-
sensing or configure both ends to operate at the same speed and duplex.
To establish a 1000Mbps connection, both ends of the link must be
i
configured as auto-sensing.
To configure Ethernet Port A, log in to the Supervisor's web interface and go to
Hardware > Blades
online help accessible from the Supervisor's web interface.
Step two: Assign an IP address to the ISDN gateway
You can use the Supervisor's web interface to configure the IP addresses of all blades
installed in the MSE 8000. Note that all blades are supplied with DHCP enabled. You
can either keep this setting or assign static IP addresses to a blade from the
Supervisor's web interface. To view or configure the IP address of the ISDN gateway,
log in to the Supervisor and go to
the ISDN gateway, go to
. For more information about configuring the port, refer to the
Hardware > Blades
Hardware > Blades
. To access the web interface of
and click the IP address of that blade.
Initial configuration
10