Epson TM-H6000IIIP 개발 매뉴얼 - 페이지 26

{카테고리_이름} Epson TM-H6000IIIP에 대한 개발 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson TM-H6000IIIP 26 페이지.
Epson TM-H6000IIIP에 대해서도 마찬가지입니다: 개발 매뉴얼 (45 페이지), 개발 매뉴얼 (32 페이지)

Epson TM-H6000IIIP 개발 매뉴얼

Section 4. Warnings

This section describes precautions in use of TM-H6000III.
Due to hardware limitations and the position of the Slip, it is not possible to
change the printing side and then search for the position where printing should
start. In this case, OPOS_E_ILLEGAL (OPOS_EX_INVALIDMODE) is returned.
Before switching the printing side, the Transaction data and the data for
90-degree rotated printing are printed on the current printing side, and
Transaction is automatically set to PTR_TP_NORMAL and Rotate is set to
PTR_RP_NORMAL.
This is because different functions are used for the two printing sides (the print
head is different) and this factor may cause an improper result if the data is not
printed on the printing side selected when the printing command is issued.
Because this processing is performed before the position of the Slip is checked in
order to take the above mentioned restrictions into consideration, there may be
instances where the above error is generated after the buffered data is printed, or
the printing side may not be switched.
In the SetBitmap method, a data set to print on the face side cannot be printed on
the backside.
The width limitation on 90-degree rotated printing to the right is limited to 831 dots
for printing on receipt. For printing on slip, it is limited to 704 dots.
If 2-color thermal paper is selected from the "Device Specific Settings" dialog box,
2-color thermal receipt paper must be used in the printer.
23
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-H6000III)
Version 3.00 Feb. 2019